Part Number	Description	Status	VCCA(Min)(V)	VCCA(Max)(V)	VCCB(Min)(V)	VCCB(Max)(V)	Max Data Rate(Mbps)	No. of Bits	Operating Temperature Range(℃)	Pin/Package	EV Kit Available?
UM74AVC8T245UO	8-Bit Dual-Supply Bus Transceiver With Configurable Voltage Translation and 3-State Outputs	Preview	1.0	3.6	1.0	3.6	400	8	-40 to 125	24/TSSOP

View All>>
Product Description

 

The UM74AVC8T245 is designed for asynchronous communication between two data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level of the direction-control input (DIR). The output-enable (/OE) input can be used to disable the outputs so the buses are effectively isolated.

The UM74AVC8T245 is designed so that the control pins (DIR and /OE) are referenced to V_CCA voltage.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, thus preventing damaging current backflow through the device when it is powered down.

The V_CC isolation feature is designed so that if either V_CC input supply is below 100mV, all level shifter outputs are disabled and placed into a high impedance state.

To put the device into the high-impedance state during power up or power down, tie /OE to V_CC through a pull-up resistor; the current-sinking capability of the driver determines the minimum value of the resistor.

The UM74AVC8T245UO is available in TSSOP24 package.

Analog Switch Permits Port Sharing in Portable Equipment.pdf

Balanced Modulator Demodulator Employing UM4684.pdf

Level Shifter for High Speed and Wide Voltage Range Interface.pdf

Low Resistance Analog Switches Permit Speaker Switching in Audio Devices.pdf

Low-Icct Analog Switches for Ultra-Portable Designs.pdf

Selecting the Right CMOS Analog Switch.pdf

Interface and System Interconnect Selection Guide.pdf

Parametric Search